Configuring The Remote Keypad(S); Zone Types; Description Of Zone Types - Texecom Veritas 8 Installation Manual

1) If selecting one of the options which incorporate latching sensor reset (2, 3
or 6) the user can force a latching sensor reset, to clear the Latch/FTA
indication, by entering their code and pressing
2) The SW+ output can only sink (not source) current. If powering detectors from
the SW+ output, connect the detector +Ve to AUX+ and the detector -Ve to
SW+. It may be necessary to invert the SW+ polarity (section 3.2.3, page 22).

3.8 Configuring the Remote Keypad(s)

From the Programming Menu, enter
lights corresponding to remote keypads (RKPs) that are currently configured and
on-line, while flashing the zone lights corresponding to RKPs that are currently
configured but off-line.
To update the configuration, press
addresses 1 to 6. As each RKP is detected the control panel will configure it as
present and illuminate the zone light corresponding to its address.
To leave configuring, press
panel will sound an error tone. The system will automatically revert to the
Programming Menu and all the zone lights will illuminate.
1) NEVER set two RKPs to the same address.
2) Setting the address of an RKP is described in the remote keypad
instructions.
3) If an RKP is configured but off-line the system will have a tamper fault.
4) ALWAYS power down the control panel when wiring a remote keypad
(RKP).
5) If an older version remote keypad has been fitted the system must be
programmed for old style sounds as follows: Enter the Engineer code
, press
++++
.
-

3.9 Zone Types

The Zone Type of a zone determines how the system will behave when the zone is
opened.
3.9.1

Description of Zone Types

The Veritas supports eight different Zone Types as follows:
Zone Type Number
INS 034-9
!( . The control panel will turn on the zone
. The control panel will scan for RKP
,
. If the configuration has not been updated the
-
, enter , press
, !!
Zone Type
1 Push to Set
2 Inhibited Entry
3 Guard
4 Fire
5 Tamper
6 Entry/Exit
7 Personal Attack (Panic)
8 Keyswitch
Programming
.
-
!(
, press , press
* ,
27