ADJ InnoRollLED User Instructions page 5

Inno Roll LED
ADDR -
DMX Address Setting.
1. Press the MENU button until "ADDR" is displayed, press
ENTER.
2. The current address will now be displayed and flashing.
Press the UP or DOWN buttons to find your desired address.
When you have found your desired DMX address press ENTER
then press and hold the MENU button for at least 3 seconds to
set your desired DMX address.
SLND -
This will let you set unit as a master or slave in a
master/slave configuration.
1. Press the MENU button until "SLND" is displayed, press
ENTER. Either "SL 1" or "SL 2" will be displayed.
2. Press the UP or DOWN buttons until your desired setting is
displayed, press ENTER to confim.
NOTE: In a Master/Slave configuration you can set one fixture
to Master and then set the next fixture to "SL 2", the fixtures will
now have contrast movement to each other.
SHND: SH 0 - SH6
- Show modes 0-6 (Factory programs).
Show mode can run with or without sound active mode.
1. Press the MENU button until "SHND" is displayed, press
ENTER.
2. "Sh X" will now be displayed, "X" representing a number
between 0-6. Programs 1-6 are factory programs, while "Sh 0"
is random mode. Press the UP or DOWN buttons to find your
desired show.
3. When you have found your desired show press ENTER, then
press and hold the MENU button for at least 3 seconds to acti-
vate. After you have set your desired show, it can be changed
American DJ - www.americandj.com - Inno Roll LED Instruction Manual Page 9
®
System Menu Inno Roll LED
at any time using the UP or DOWN buttons.
SPLC -
output will be split and whole.
1. Press the MENU button until "SPLC" is displayed, press
ENTER.
2. The display will show either "YES" or "NO". Press the UP or
DOWN buttons to select "YES" to activate split color mode, or
"NO" to deactivate split color mode.
3. Press ENTER to confirm.
DCAL -
sity.
1. Press the MENU button until "DCAL" is displayed, press
ENTER.
2. A number between 50-100 will be displayed. Press the UP
or DOWN buttons to adjust the LED output intensity. 50 being
medium intensity, and 100 being full intensity.
3. When you have found your desired setting press ENTER to
confirm.
SOUN -
1. Press the MENU button until "SOUN" is displayed, press
ENTER.
2. The display will show either "ON" or "OFF". Press the UP or
DOWN buttons to select "ON" to activate sound active mode, or
"OFF" to deactivate sound active mode.
3. Press ENTER, then press and hold the MENU button for at
least 3 seconds to activate.
Split Color mode. With this mode active, color
In this mode you can adjust the LED output inten-
Sound Active mode.
American DJ - www.americandj.com - Inno Roll LED Instruction Manual Page 10
®
System Menu