ADJ InnoRollLED User Instructions page 10

Inno Roll LED
Channel Value
8
130 - 199
200 - 209
210 - 239
240 - 255
American DJ - www.americandj.com - Inno Roll LED Instruction Manual Page 19
®
8 Channel Mode
Function
RESET/BLACKOUT
NO FUNCTION
RESET ALL
NO FUNCTION
SOUND ACTIVE
Inno Roll LED
This unit comes with interchangable gobos. When changing
the gobos please be very careful. Follow the instructions below,
and see the figure pictures on the next page.
Caution! Never open the unit when in use. Always disconnect
the main power before attempting to change the gobos.
1. Start by standing the fixture upright so that it is sitting on the
bottom handles. Unscrew the two phillips screws located on
the front panel just underneath the air vents.
2. Carefully remove the front panel to access the gobo wheel.
3. Rotate the gobo wheel with your hand until you find the gobo
you would like to change.
4. Using a pair of needle nose pliers, grab the retainer ring that
holds the gobo in place and remove the ring. You can also
remove the gobo by carefully pushing the gobo from the bot-
tom, pushing it up and out. Do this carefully so that you don't
lose the retainer ring and the gobo.
5. Once you have removed the gobo carefully insert your new
gobo and reinsert the retainer ring.
6. Reassemble the unit.
American DJ - www.americandj.com - Inno Roll LED Instruction Manual Page 20
®
Gobo Replacement