Functional Description; Product Specifications; Unpacking - Delta 31-483 Operating Instructions And Parts Manual

Heavy Duty Oscillating Bench Spindle Sander is designed for sanding or polishing flat, round, or curved surfaces on
wood and plastic materials.
Oscillation rate
Oscillation stroke
Spindle Speed
Motor
Table Size
Table Tilt
Spindle Size Range
Dust Chute
Base Dimensions
Weight
The machine is heavy, be careful when removing it from the shipping container! Failure to comply
may cause serious injury and/or damage to the sander and/or property!
®
Your DELTA Heavy Duty Oscillating Bench Spindle Sander comes packed in a single container. Use a safety strap to
avoid tip-over when lifting machine. Check shipping carton and machine for damage before unpacking.
Open the shipping container. Carefully remove packaging materials, parts and machine from shipping carton. Always
check for and remove protective shipping materials around motors and moving parts. Lay out all parts on a clean
work surface and check that all parts are present and in good condition:
Oscillating bench top spindle sander (1)
2" to 4" dust port adaptor (1)
1/4" sanding spindle (1)
1/2" sanding spindle (1)
5
/ " sanding spindle (1)
8
1 ½" sanding spindle (1)
Compare the items to inventory figures; verify that all items are accounted for before discarding the shipping box.
Report any missing or damaged parts to your distributor or dealer. Prior to tool assembly and use, read this manual
thoroughly to familiarize yourself with proper assembly, maintenance and safety procedures.
Remove any protective materials and coatings from all of the parts and the drum sander. The protective coatings
can be removed by spraying WD-40 on them and wiping it off with a soft cloth. This may need redone several times
before all of the protective coatings are removed completely.
If any parts are missing, do not attempt to plug in the power cord and turn "ON" the machine. The
machine should only be turned "ON" after all the parts have been obtained and installed correctly.

FUNCTIONAL dESCRIPTION

PROdUCT SPECIFICATIONS

29 strokes/min
15⁄16" (24 mm)
1720 Rpm
½ Hp, 110 V, 7.5 A
14 ½ " X 14 ½ " (368 X 368 mm)
0° to 45°, 0° to -45°
¼ " - 3" (6.2 - 50.8 mm)
2" (50.8mm) with 4" (101.6mm) Adapter
14 ½ " X 14 ½ " (368 X 368 mm)
81 lbs (37 Kg)

UNPACkINg

dESCRIPTION (QUANTITY)
2" sanding spindle (1)
1/4" sanding sleeve (1)
1/2" sanding sleeve (1)
5
/ " sanding sleeve (1)
8
1 ½" sanding sleeve (1)
2" sanding sleeve (1)
7
3/4" oblong table insert (1)
3/4" round table insert (1)
2"oblong table insert (1)
2" round table insert (1)
10-12 mm wrench (1)
14-17 mm wrench (2)