Cleaning The Scanner - Kodak i100 Instruction Manual

I. i i i i i 260

Cleaning the scanner

The scanner will collect dust and other debris during routine scanning.
For optimal scanner performance, follow the detailed cleaning instructions
in this section and clean the feed module rollers, separator module rollers,
imaging guides, transport area, and paper path at least once per week.
Clean the scanner and paper path daily if you are scanning carbonless
paper or newsprint, or if you are using the imprinter.
Use only these cleaning materials:
Kodak Digital Science Roller Cleaning Pads (24)
Staticide Wipes for KODAK Scanners (144)
Kodak Digital Science Transport Cleaning Sheets (50)
Staticide Wipes contain isopropanol which can cause eye
irritation and dry skin. Wash your hands with soap and
water after performing maintenance procedures. Refer to
the Material Data Safety Sheet (MSDS) for more information.
The MSDS is available on the Kodak web site at
www.kodak.com/go/MSDS.
Allow all rollers to dry completely before using the scanner.
The use of any other cleaning materials could damage your scanner.
Use fresh cleaning material unless otherwise indicated.In addition
to the recommended cleaning supplies, you may use a vacuum
cleaner to remove debris from the scanner. Some debris from the
rubber tires on the feed module and separator module is normal.
Tire debris does not always mean that the tires are worn or damaged.
After cleaning, inspect the tires for wear and replace the separator
module or feed module if necessary.To order cleaning supplies, refer
to Appendix B, Supplies and Accessories.
2
Versitec 1- 888 - 722 - 6548
260 260 Maintenance Maintenance
260 Maintenance 260 Maintenance Maintenance
Item
IMPORTANT
NOTE:
CAT No.
853-5981
896-5519
169-0783
www. versitec.com