Testing For Continuity - TECPEL DCM-033 Operating Manual

D. Testing for Continuity (see figure 6)
Warning
To avoid damages to the Meter or to the devices
under test, disconnect circuit power and discharge
all the high-voltage capacitors before measuring
continuity.
To test for continuity, connect the Meter as follows:
1. Insert the red test lead into the Hz Duty%
terminal and the black test lead into the
COM terminal.
2.
Set the rotary switch to
3. button to select
The buzzer sounds if the resistance of a circuit
under test is less than 50
The buzzer may or may not sounds if the resistance of a circuit under test is
4.
between 50 to 100
The buzzer does not sound if the resistance of a circuit under test is higher than
5.
100
and press SELECT
measurement mode.
24
Red Black
(figure 6)