Hitachi RU-3400JY/VR S10 Operating Instructions Manual page 28

Item
Function
no.
Manual adjustment
１ ６
* Adjustment
value display
1 Detail Adjustment
(1)DTL LEVEL
(2)LEVEL DEP /
BOOST FREQ
(3)CRISP /
DTL SOURCE
Switch
・Select adjustment items with the manual
control section switches.
section shows the adjustment item and
value.
・Use the rotary encoder to adjust the items
for optimum values.
・When the
CTL VALUE
adjustment value is displayed from -100 to
+100.
【 Display example】
【 Display】
DTL 1
TOTL: Total detail level adjustment
V: V detail level adjustment
・Press again the switch for the following
DTL 2
display.
LDPP: Dark component noise due to detail
FREQ: Adjusts detail boost frequency (13 M to 19
・Press Again the switch for the following
DTL 3
display.
H-CR: Noise component reduction due to H.
V-CR: Noise component reduction due to V. detail.
SRC: Detail signal source (R,RG,RGB) selection.
16
Operating procedure
switch is on, the
CTL VALUE
GAIN
-20 0
DETAIL LEVEL
TOTL H
H: H detail level adjustment
LEVEL-DEP / FREQ
LDPP
reduced
M).
CRISP / SOURCE
H-CR V-CR
detail.
The display
+10
V
FREQ
SRC