RC Logger RC EYE One Operating Instructions Manual page 29

1. Switch.off.the.remote.control.transmitter.by.pushing.the.on/off.button..The.transmitter.confirms.this.with.
a double sound.
2. Put the throttle lever all the way back (engines out).
3. Resets the trims at the transmitter to "0". For this, push the two associated trim buttons for rudder, nick
and.roll.(also.see.the.figure.in.OPERATING.ELEMENTS.OF.THE.TRANSMITTER.AND.RC.EYE.ONE,.
items 4, 6 and 7 of 88003RC (mode 2) Transmitter / items 4 and 6 of 88004RC (mode 3) Transmitter) in
sequence.until.neutralisation.of.the.trimming.is.confirmed.with.a.double.sound.signal.
4. Then.connect.the.flight.battery..For.this,.push.the.battery.plug.into.the.socket.of.the."RC.EYE.One".in.the.
correct.polarity.(also.see.he.figure.in.OPERATING.ELEMENTS.OF.THE.TRANSMITTER.AND.RC.EYE.
ONE,.Model.Bottom,.item.3;.observe.plug.contours)..The.LED.in.the.model.starts.flashing.green.after.a.
short period at a correct reception signal (starter mode).
5. Place.the.flight.battery.into.the.intended.holder.of.the."RC.EYE.One".and.secure.it.with.hook-and-loop.
tape. (also. see. he. figure. in. OPERATING. ELEMENTS. OF.THE.TRANSMITTER.AND. RC. EYE. ONE,.
Model Bottom, items 2 and 4).
6. Push.the.setting.bottom.of.the.flight.mode.(figure.6,.item.1).to.select.the.desired.mode.
- LED.flashes.green.=.beginner's.mode.(basic.configuration.after.each.battery.change)
- LED.flashes.orange.=.sports.mode
- LED.flashes.red.=.expert.mode
7. Place.the.model.on.a.level.surface.as.smooth.as.possible.(e.g..stone.floor)..A.carpet.is.less.suitable.
because the landing legs may bet caught in the carpet easily.
8. Start the engines by carefully pushing the throttle lever forwards. Ideally, now slowly increase the speed
of the rotors (the throttle) of the "RC EYE One" until you can see a slight increase of altitude. Test the
roll and nick directions just before the "RC EYE One" starts to hover to ensure that the transmitter is
correctly.set..Generally.avoid.any.fast.and.big.controlling.motions..Also.watch.closely.to.see.whether.
and in which direction the "RC EYE One" moves. By using trimming on the remote control, you can
prevent undesired movements.
Important! Never take off with a badly trimmed flight device.
9. Then increase the throttle until the "RC EYE One" is at least 50 cm above the ground. At this height, you
have.passed.the.so-called.ground.effect.and.the."RC.EYE.One".is.more.stable.in.its.flight.position.and.
can be controlled more easily. Carefully try to correct a gentle drift with the trim levers for rudder, nick
or roll. Once the "RC EYE One" is high enough in the sky, decrease the throttle until the "RC EYE One"
hovers. Also observe the notes in chapter INFORMATION FOR FIRST TAKE-OFF.
10. Now you have managed the critical part and can familiarise yourself with the "RC EYE One" by slow and
careful throttle controlling motions.
29