LG ThermaV Owner's Manual page 29

Installer Setting-Setting Indoor Air Temperature range for Weather-dependent operation
Determining setting temperature (by air) concerned with autosetting of setting temperature according
to Outdoor air Temp. Two points, y1 and y2 in the Temperature Profile, are chosen.
❊
Note
• All values are in °C.
• Selection of °C or °F is based on
the value of Function Code 04.
Temperature Profile
Setting Temp
(Air)
y1
y2
Value #2
Value #1
1
Keep pressing Function Setting
button for 3 seconds to enter
installer setting mode until
code displayed in timer segment.
2 Repeat pressing button to select
Function code 24.
Value
Value #1
Value #2
3 Set the Value #1 by pressing up, down button.
Ex) setting Value as Value #1 = '25'
4 Move to Value #2 part by pressing right
direction button.
5
Set the Value #2 by pressing up, down
button.
Outdoor
air Temp.
6 If you finish the setting, press set / clear
button to save the setting.
7
Press
automatically exit after 25 seconds
without any input.
Installation instruction
Note Default
Upper Limit of setting range
Lower Limit of setting range
Value #2 = '20'
button to exit or system will
Owner's Manual 29
Value #1
Value #2
Range
30 26~30
25 16~25