LG ThermaV Owner's Manual page 17

Installer Setting -Setting Temperature Selection
The product can be operated according to air temperature or leaving water temperature. The
selection for setting temperature as air temperature or leaving water temperature is determined.
❊
Note
Air temperature as setting temperature is ONLY available when Remote Air Sensor(PQRSTA0)
Connection is enabled and Function Code 03 is set as 02.
1 Keep pressing Function Setting button
for 3 seconds to enter
installer setting mode until
code displayed in timer
segment.
2 Repeat pressing button to select
Function code 05.
3 Set the value by pressing up, down button.
Value Note
01 Air temperature
02
Leaving Water temperature
4 If you finish the setting, press set / clear
button to save the setting.
5
Press button to exit or system will
automatically exit after 25 seconds
without any input.
Installation instruction
Default
02 : Leaving Water
temperature
Owner's Manual 17