W
iring diagram
Fig.D-3
Lead wires of LED circuit before putting Switch into Housing set (L)
Fix Lead wires into Lead wire
holders or with Rib and Boss.
Lead wire holder
Fig.D-4
Lead wires of Brush holder complete to Switch
Assemble each Lead wire
connecting terminal to
Switch at approx. 20° left
from the vertical line.
M1 Terminal
Assemble Lead wire (red)
with M1 terminal to Switch
vertically.
Fig.D-5
Pigtails on Brush holder complete
Pigtails of Carbon brushes
have to be put in the areas
designated in gray color
without being projected
when Brush holder complete
is set in place.
Do not slack Lead wires around here. Never pinch them between Ribs/ Bosses
of Housing set (L and R).
The space between Rib and Boss is allowed to use as Lead wire holder.
Lead wire holder
Specifications without Line filter
20°
Specifications with Line filter
20º
M2 Terminal
Assemble Lead wire (black)
with M2 terminal to Switch
at approx.
20° left
the vertical line.
9mm
Pigtail of Carbon brush
Rib
LED
Boss
Do not cross the lead wires in this range.
M1 Terminal
Fully bend M2 terminal
of Lead wire (black)
from
to reserve the space
for Line filter.
Brush holder end
9mm
P 9/ 11
M2 Terminal