Wiring Diagram - Makita BTW152 Technical Information

W
iring diagram
Fig. D-2
1. Lead Wires of LED
Fix LED lead wires (red, black) with lead wire holder,
then route between pin and boss as illustrated below.
Lead wire holder
pin
boss
2. Other Lead Wires
Brush holder complete
Assemble each Connecting
terminal to Switch at approx.
20 degrees to the vertical.
Lead wire holder
Fix the lead wires connected
to each connector with these
lead wire holders.
Connector (large)
Connector (small)
Put the following lead wires
between the rib and Light circuit.
* Lead wires (red, black) from
Terminal to Connector (small)
* Lead wire (blue) from Switch
to Connector (small)
Lead wire holder
Do not cross LED lead wires (red, black) here.
rib
Terminal
Fit the corner of LED against the corner
LED
of Housing (L) as illustrated below.
Do not slack LED lead wires
(red, black) in this area.
20 degrees
Switch
P 10/10
LED
The lead wire (blue) from
Connector to Switch has to
be routed inside of this pin.
Pin
Light circuit
Put Light circuit in place
so that the orange lead wire
faces toward the Terminal side.
Switch side
Lead wire
(orange)
Terminal side