Wiring Diagram - Makita TD090D Technical Information

W
iring diagram
Fig. D-2
Pay attention to the directions of lead wires and connect Flag receptacles
to electrical parts.
Refer to the following illustration.
Terminal
Fig. D-3
Before installing Switch in Housing R, route Lead wires as illustrated below and connect two Connectors.
Do not put their Lead wires on the ribs of Housing L.
Connector
Fig. D-4
Bend the terminals of DC motor
as illustrated.
Flag receptacles and
Lead wires have to
be far from DC
motor.
Do not put them
on the ribs.
Fix Lead wires
with Lead wire
holders.
red marking
DC motor
Lead wire holders
Housing L
(To Switch)
Connector
Lead wires have to fixed
with the ribs.
Route Lead wires between ribs.
Lead wires in this area
must be tight.
Face the glue-attached portion of LED
downward.
Lead wires between Connector and
Switch have to be placed behind Switch.
Do not ride Lead wires on the screw embosses.
P 6/ 6
LED
Insert Connectors between
their Lead wire holders.