Makita BTD146 Technical Information page 11

W
iring diagram
Fig.D-8 (Specifications for LXDT03/ LXDT04)
Tilt Insulated terminals on
Lead wires' ends to 20°
from the vertical line
on the machine.
Brush holder
complete
Do not put any Lead wires
on Seal.
Fig.D-9
Flag terminals
20°
Switch
Seal
Connectors
Sponge A
Receive the tube for Lead wires
with the groove of Sponge A.
Lead wire holders
Lead wires connected to each connector
have to be fixed into Lead wire holders.
Lead wires have to be passed over the center of Terminal
with the flag terminal ends set in place.
The center of Terminal
LED job light
P 11/ 11