Attach External Tray And Handle To Housing - Ikelite 6146.16 Instruction Manual

Initial Camera Setup
- Set Macro mode
is overexposed, use "-" Flash Exposure Compensation
and/or back away, zoom in, and then reshoot.
Notes:
TTL Flash is NOT available when camera is in "M" Manual mode. There
is no TTL flash even with Canon's own flash in the camera "M" mode.
Manual power settings can be selected in the "Flash Control" section of
the camera menu. The strobe should still be left in TTL mode to take
advantage of this feature.
Leave the housing hotshoe disconnected when using ONLY the camera
flash and no external strobes, or when using an EV manual
controller. If using an EV controller in "M" Manual mode, set the EV
controller to "non Pre-flash."
When multiple exposure (continuous shooting) mode is used with a
non-TTL flash, the external flash will not fire.

Attach External Tray and Handle to Housing

Using a 9/16" open
end or socket Wrench
(not supplied), tighten
the External Tray to
the Housing Base
using the two 3/8-16
Nuts supplied in the
accessory package;
tighten Nuts firmly.
External Tray & Handle
6
(continued)
to "On" when shooting close-up. If the image
3/8-16 Nut
Wrench - not supplied