Attach External Tray And Handle To Housing; Attaching Ikelite Strobe Arm To Housing Handle - Ikelite 6171.07 Instruction Manual

Attach External Tray and Handle to Housing

1. Place your housing upside
down on a flat surface or
your lap so that the hous
ing port is facing toward
you as shown in Diagram C.
2. Line up the 3/8" tray holes
with the housing mounts. If
the tray is positioned
properly, the handle will be
on your left side facing down.
3. Place a shoulder washer in
each 3/8" tray hole with the
small end of the washer facing down.
4. With your free hand, insert and rotate the 12-24 x 1/2" screws clockwise
until threaded into the housing mounts. Finish tightening the tray to the
housing using a flathead screwdriver. Do not overtighten.

Attaching Ikelite Strobe Arm to Housing Handle

If you have purchased an Ikelite Tray
and Handle for your housing, refer to
diagram D to attach an Ikelite Arm.
To attach an Ikelite Arm to your
Housing Handle, depress the
spring-loaded Handle Push Button
until it stops. Gently slide the pronged
end of the Ikelite Arm into the hole in
the top of the Handle as shown.
When the Ikelite Arm is properly
seated, the Handle Push Button will
return to it's starting position.
14
Diagram C
Ikelite Arm
Diagram D
Housing Handle
Handle Push
Button