Attach External Tray And Handle To Housing - Ikelite 6146.01 for Canon G1 X Instruction Manual

Initial Camera Setup
- Set Image Quality to "L" and compression to "Fine."
- Set Macro mode
is overexposed, use "-" Flash Exposure Compensation
and/or back away, zoom in, and then reshoot.
Notes:
TTL Flash is NOT available when camera is in "M" Manual mode. There
is no TTL flash even with Canon's own flash in the camera "M" mode.
Manual power settings can be selected in the "Flash Control" section of
the camera menu. The strobe should still be left in TTL mode to take
advantage of this feature.
Leave the housing hotshoe disconnected when using ONLY the camera
flash and no external strobes, or when using an EV manual
controller. If using an EV controller in "M" Manual mode, set the EV
controller to "non-Pre-flash."
When multiple exposure (continuous shooting) mode is used with a
non-TTL flash, the external flash will not fire.

Attach External Tray and Handle to Housing

Using a 9/16" open
end or socket
wrench, tighten the
External Tray to the
Housing Base using
the two 3/8-16 Nuts
supplied in the
accessory package;
tighten Nuts firmly.
External Tray & Handle
6
(continued)
to "On" when shooting close-up. If the image
3/8-16 Nut
Lens
Port