Initial Camera Setup - Ikelite 6146.16 Instruction Manual

Initial Camera Setup

- Insert a fully charged camera battery.
- Set Mode Dial to "Av" Aperture Priority and ISO to "200."
- Raise Flash and set to "Flash always fires
- In MENU:
Push button and move to the center. Set Digital Zoom to "Off."
Set AF-Point Zoom to "Off" and Set Servo AF to "On."
Set Continuous AF to "Off" and AF-assist Beam to "Off."
Set MF-Point Zoom to "2X" and Safety MF to "On."
In the Flash Control Built-in Flash Settings Menu, set Red-eye Corr.
and Red-eye Lamp to "Off."
Set Review Image after Shooting to "4 sec." and Display Info to "Off."
Set Blink Detection to "Off" and IS Settings Mode to "Continuous."
Set Spot AE Point to "Center" and Safety Shift to "Off."
Set Shortcut Button to
In MENU:
-
Set Date/Time and Time Zone.
Set Lens retract to "1 min" and Eco Mode to "Off."
In the Power Saving Menu, set Auto Power Down to "Off" and Display
Off to "3 min."
Insert and Format an SDHC memory card.
In FUNC./SET MENU:
-
Set DR Correction to "Off" and AWB White Balance to "Auto."
Set White Balance to "AWB." For best results, use manual
White Balance and reset for each working depth.
Set Drive Mode to "Single Shot
Set Metering to "Center Weighted Avg.
Set ND Filter to "Off" and Still Image Aspect Ratio to "4:3."
Set Image Type to "JPEG 12M" and Image Compression to "L."
Set Image Quality to "Superfine" and Movies to "FHD/60P."
(before placing camera in housing)
Custom White Balance or desired setting.
."
."
"
Custom
5