Installing The System Into A Two-Post Rack Or Cabinet - Dell S4810–ON Installation Manual

To attach the brackets to the system, follow these steps.
1. Take the brackets and screws out of their packaging.
2. Attach the brackets to the PSU sides of the system using four screws for each bracket. Attach the
bracket so that the "ear" is parallel to the PSU and the outside of the system.
Figure 4. Attaching Mounting Brackets into a Two-Post Rack or Cabinet
1. View from the chassis I/O side
3. Screws
5. Connect to the Rack or Cabinet (ears)

Installing the System into a Two-Post Rack or Cabinet

Ensure that there is adequate clearance surrounding the rack or within the cabinet to permit access and
airflow.
To install a system into a two-post 19-inch equipment rack using the already attached mounting
brackets, follow these steps.
16
2. Connect to the Rack or Cabinet (ears)
4. Screws
6. Power Supply
Install the S4810–ON