Rear Panel; Power Switch; Ac Power Connector; Aui Port - Kingston Technology KNE16TP/RS User Manual

8

Rear Panel

PORT #16 OR PORT #24
CASCADE CONFIGURATION
BNC
STACK-IN STACK-OUT
For cascading to another MDI-X
hub port using straight-thru cable.
For connection to workstation NIC
using cross-over cable.
For cascading to another MDI-X
hub port using cross-over cable.
For connection to workstation NIC
using straight-thru cable.

Stacking Ports

BNC Port

Fig. 2. Hub Rear Panel

Power Switch

The power switch toggles power on and off to the unit. The switch can also be
used to reset the hub.

AC Power Connector

The EtheRx hubs use an auto-sensing 100VAC-240VAC, 50/60Hz internal
power supply. Connect the AC power cord from the rear of the unit to an AC
electrical outlet.

AUI Port

The AUI port is a 15-pin D-sub connector. It is a general purpose port for
backbone or mixed media connections for 10BASE2, 10BASE5, 10BASE-T,
or FOIRL connections using a proper external transceiver.
BNC Port
This port is labeled BNC, and has a built-in transceiver for direct 10BASE2
connection using thin coaxial cable. Use RG-58 A/U or RG-58 C/U type
cable. Refer to Appendix B for 10BASE2 cabling guidelines when connecting
to this port.
Stacking Ports
The two ports are labeled"Stack-In" and "Stack-Out" for stacking up to five
(5) EtheRx Pro-Series hubs in any combination of 16-Port and 24-Port models.
Refer to the section, "Stacking EtheRx Hubs" on the next page for instructions.
Kingston Technology Company
Hardware Installation
100-240VAC 50-60HZ 1A
1% Green UTILIZATION % - Bar graph indication
7% Green
(in percentage) of the traffic rate in
EXTERNAL TRANSCEIVER UTIL %
15% Green reference to the 10 Mbps Ethernet
( SQE JUMPER DISABLED)
30% Amber bandwidth.
60% Orange
1%
Amber COLLISION % - Bargraph indication
7%
Amber (in percentage) of the packet collision
COLL %
15%
Amber rate in the network.
30%
Amber
AUI 60%
Red
AC Power Power
AUI Port
Connector Switch
KNE24TP/RS User's Guide - Rev. A01
ON
OFF