Handle Assembly - Kenmore VACUUM CLEANER 116.32289 Owner's Manual

Before assembling vacuum, check the
PACKING LIST on the cover of the separate
Repair Parts LisL Use this list to verify that
you have received all the components of
your new Kenmore vacuum,
WARNING
Electrical Shock Hazard
Do not plug into the electrical sup-
ply until the assembly is complete.
Failure to do so could result in
electrical shock or injury.
,,,,,,,,,,,,,,, ,
HANDLE ASSEMBLY
Before assem- (_
biing your vacu-
um cleaner be
sure you have all
the parts shown,
Remove the screw located just below the
carry handle on the back side of
the vacuum.
Carry
Handle
Position the
handle so
the cord
hooks are
toward the
back of the
cleaner.
Insert the
handle into
the opening
at the top
of the vacu-
um,
Cord
y Hooks
Screw
Hole
_ Handte
I Screw
Hole
Align the screw hole in the handle with
the screw hole in the vacuum.
insert the screw so it passes through the
back of the vacuum into the handte
Begin to tighten the screw with your fin-
gers It may be necessary to adjust the
handle slightly,
Carny Handle
Using a screwdriver, tight-
en the screw,
CAUTION
Do not overtighten,
Overtightening could strip the
screw holes.
Do not operate the cleaner without
the screw in place°