Table of Contents
Advertisement
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC)
installed on the system board and you wish to use it. If you install
an add-in FDC or the system has no floppy drive, select Disabled in
this field.
Onboard UART Ports (1, 2)
Select a logical COM port address for the first and second serial
ports.
RxD, TxD Active
Consult your IR peripheral documentation to select the correct
setting of the TxD and RxD signals.
ECP Mode Use DMA
Select a DMA channel for the port.
EPP Mode select
Select EPP port type 1.7 or 1.9.
Onboard Serial Port 3.
Serial Port 3 Use IRQ.
Onboard Serial Port 4.
Serial Port 4 Use IRQ.
76
PCM-5896 User Manual
Advertisement
Table of Contents
