Acom SI-1 Owner's Manual page 8

If the display stays at SEt
once, then the parts are too light
7. If the sample met the proper criterion, then you will see a count on
the display. See the chart below to determine the Minimum Piece
and Sample Weights
8. Remove the sample from the platter
9. If necessary, follow directions for entering a tare
10. Place a sample of quantity to be counted
11. Once the STABLE light is on you may read the pcs
12. Remove sample from the platter and repeat steps 10 thru 12 as
many times as necessary or proceed to step 13
13. If necessary, follow directions for removing a tare
Minimum Piece Weight
Minimum Sample Weight
Maximum Quantity
Limit Mode (lb only)
1. Press the MODE key until you reach Limit mode (Limit)
2. Make sure that the scale is at ZERO and STABLE
3. If necessary, follow directions for entering a tare
4. Press the SET key
5. The display will read Lo and then 0.00 or 0.0
6. Place the Low Limit load on the platter and press the SET key
7. The scale will display SEt momentarily and then display the
weight of the Low Limit load
8. Remove the Low Limit load from the platter
9. Place the High Limit load on the platter and press the SET key
10. The scale will display SEt momentarily and then display the
weight of the High Limit load
11. Remove the High Limit load from the platter
12. You can now use the scale in Limit mode; the display will flash
and scale will beep continuous when the weight meets the
following criteria:
0.00 < WEIGHT < Low Limit
High Limit < WEIGHT < Max Capacity
13. If necessary, follow directions for removing a tare
6
100 after you press SET more than
Parts Counting Specifications
150 lb (60 kg)
0.05 lb (0.02 kg)
5 lb (2 kg)
SI-1
300 lb (150 kg)
0.1 lb (0.05 kg)
10 lb (5 kg)
3,000 pcs