Infinity 6250LQ Operation Manual page 37

" button, print the bidirection compensate image.
4) Press"
5) Check the image to find a straight line. Reset the values on Adjustment \ Bid adjust according to
the data above the line.
6) Follow the same steps above, get Bidirection compensate results at different speed setting.
3、Feed compensate
There are different feed compensate results for different pass number you selected.
To compensate feeding on Y direction, following by:
1) Select 360x180 1Pass，Adjustment\Rectangle on operation control board is not available for
6250LQ. Press ONLINE make printer Online Mode.
2) In 6320LQ Try，open testing file named 180.group
Figure 10-2-12 Feeding compensation image (180.group)
"
3) Press" button，start to print
4) Check the swatch, see if the lines are even (better check by microscope); if not, back to Figure
10-2-7 to adjust parameters until all lines are even, then click on "OK".
5) When select 360x270 1Pass， open 270.group, following the rules above to reset the parameters,
and then click on "OK".
6) Step1 to 4 can be applied for different pass settings.
4、Print head voltage curve
Press" Voltage Curve" button, pop up a dialog box as below:
FY operation manual
Figure10-2-11 Bidirection compensate image
- 37 -