Infinity 6250LQ Operation Manual page 16

4. Jam Test
Press ENTER key, device will print test draw directly. It is the same when pressing FUNC key in Offline
mode.
5.2.3 Adjustment
MENU
M3
OFFINE
1. Moving Test
Press ENTER key, the LCD displays as below:
MENU → Moving Test
Press <FUNC> to
M3-1
run Test and Press
<ESC> to stop
2. Speed
Moving speed on Y direction, range from 1 to 15. Maximum is 15, however, the printing quality will go
down if 15 selected. Our suggestion is level 10 or lower, do not over 13.
3. BID adjust
MENU →
BIG Adjust
XXXX
M3-3
Press <FUNC> to
run Test Print
Refer to the software INFINITI 6250LQ (TRY) for details. Set up a speed at level 4 for best result.
Note: An engineer usually completes it. Customers do not need adjust it by themselves.
4. Rectangle
Feed compensation. This function is used to adjust the feed compensation on media moving direction
(X-Direction).
Note: This function does not work for new models with spectra.
An engineer usually completes it. Customers do not need to adjust it by themselves.
FY operation manual
Moving Test
Print Speed
BID Adjust
Rectangle
Execute it follow by hints on screen. In this case,
device is in a simulative plotting status. Print head
will not spray ink.
This function is used to adjust print head and avoid
the image dislocation when bi-directional printing
- 16 -