Infinity 6250LQ Operation Manual page 36

a) Back to Figure 10-2-2，Open the testing file named overlap-1080.group，see Figure 10-2-10:
b) Open "Print Setup", select four colors with "360x540 1 PASS" Print Mode
" to print
c) Press"
d) Check the print swatch, if four colors overlap together, the line with value of 0 is straight;
otherwise, adjust the parameters according to the values for straight lines.
After finishing the adjustment, press "Upload" to save all parameters to Printer.
3) Ignore X parameters and Ignore Y parameters
Those functions only used by engineer for testing and maintenance. Normally, users do not need them.
2、Bidirction compensate
In order to prevent image from mis-position when bidirection selected, use this function to adjust
print head. The result for Birdirection compensate is different from one to another depends on a
setting of Speed.
Operation steps:
1) Set up Adjustment\Speed (< = 13) on Menu M3-3 on the Operation Control Panel for 6250LQ.
2) Set up Adjustment\Bid Adjust to 0 on Menu M3-3 on the Operation Control Panel for 6250LQ.
Press "ENTER" to confirm, then Press "ONLINE", Printer is in Online mode.
3) From Try software for 6320LQ, open testing file BID.group.
FY operation manual
Figure 10-2-10 Testing image for X direction
- 36 -