Realignment - Kenwood TK-860G Service Manual

OPERATING FEATURES / REALIGNMENT
Key press tone [B]
Sounds when a key is pressed. For toggle keys, sounds
when the toggle function is turned off (key press tone [A]
sounds when it is turned on). You can select yes or no for
the optional feature's control tone.
Key input error tone
Sounds when a key is pressed but that key cannot be
used. You can select yes or no for the optional feature's
warning tone.
Roll over tone
Sounds in Conventional format at the smallest group/
channel. You can select yes or no for the optional feature's
control tone.
Transpond tone
Sounds when an individual call with the correct DTMF/2-
tone option signalling is received. For group calls, only the
group tone will sound, not the transpond tone.
Pre alert tone
Sounds prior to the TOT TX inhibit activation. If TOT pre
alert is set, the tone sounds at the amount of time pro-
grammed, before the TOT expires (TOT time – TOT pre alert
time = Pre alert tone sounding time). You can select yes or
no for the optional feature's warning tone.
TK-860G/

REALIGNMENT

1. Modes
User mode
Panel test mode
Panel tuning mode
(TK-860G only)
PC mode
Firmware program-
ming mode
Clone mode (TK-860G only)
Self programming
mode (TK-860G only)
Mode
User mode For normal use.
Panel test mode Used by the dealer to check the funda-
ment characteristics.
Panel tuning mode Used by the dealer to tune the radio.
PC mode Used for communication between the
radio and PC (IBM compatible).
Data programming Used to read and write frequency data
mode and other features to and from the radio.
PC test mode Used to check the radio using the PC.
This feature is included in the FPU.
See panel tuning.
Firmware program- Used when changing the main program
ming mode of the flash memory.
Clone mode Used to transfer programming data from
one radio to another.
Self programming Frequency, signalling and features write
mode to the radio.
2. How to Enter Each Mode
Mode
User mode
Panel test mode
PC mode
Panel tuning mode
Firmware programming mode
Clone mode
Self programming mode
3. For the Panel Test Mode (TK-860G only)
Setting method refer to ADJUSTMENT.
3-1. For the Panel Tunning Mode
Setting method refer to ADJUSTMENT.
( N ) /862G/
Data program-
ming mode
PC test mode
PC tuning mode
Check sum
Function
Operation
Power ON
[SCN]+Power ON (Two seconds)
Received commands from PC
[Panel test mode]+[SCN]
[CH ]+Power ON (Two seconds)
[ ]+Power ON (Two seconds)
[A]+Power ON (Two seconds)
( N )
11