Kenwood TK-860G Service Manual page 7

• Display character (TK-860G only)
This key switches the LCD display between the group
and channel number and the group and channel name.
• Emergency
Pressing this key for longer than 1 second causes the
transceiver to enter the emergency mode. The transceiver
jumps to the programmed "Emergency the group and chan-
nel" and transmits for 25 seconds.
The transceiver disables mic mute while transmitting.
After finishing transmission, the transceiver receivers for 5
seconds. The transceiver mutes the speaker while receiv-
ing. Following the above sequence, the transceiver contin-
ues to transmit and receive.
• Emergency mode system chart (TK-860G)
Foot switch 1 push
After 1 min.
Horn/Light operation
[D/A] key 1 push
Horn/Light operation stop
• Emergency mode system chart (TK-862G)
Foot switch 1 push
After 1 min.
Horn/Light operation
[D/A] key 1 push
Horn/Light operation stop
OPERATING FEATURES
Foot switch 1 push
Emergency mode
Emergency channel
TX 25 sec. ← → RX 5 sec.
or
*2
Emergency ACK code receive
Emergency reset code receive
Emergency mode reset
Normal operation
Foot switch 1 push
Emergency mode
Emergency channel
TX 25 sec. ← → RX 5 sec.
or
*2
Emergency ACK code receive
Emergency reset code receive
Emergency mode reset
Normal operation
TK-860G/
(Hold it down for about one second.)
*1
LCD dots light
*3
LCD dots light
or
*2
[MON] key + Foot SW 1 push
*1 : 3 left most dots light.
*2 : Hold the foot switch again for about one second.
*3 : 2 right most dots light.
(Hold it down for about one second.)
*1
LCD dot status change
Dot
*1
LCD dot status change
or
*2
[MON] key + Foot SW 1 push
*1 : When the dot indicator is on, it turns off.
When the dot indicator is off, it turns on.
*2 : Hold the foot switch again for about one second.
( N ) /862G/
Dots
Dots
Dot
( N )
7