Kenmore 19501 Owner's Manual page 42

C
Zipper teeth
C_
1.
,
3,
J
Sew in the zfpper,
Fold back the Jeft seam allowance as
shown,
Turn under the right seam allowance to
form a 1/8"' foid.
Place the zipper teeth next to the 1/8"
fold and pin in place.
NOTE: Be sure the top of the zipper
(the stider) is at the top of the
garment.
/
4. Attach the presser bar to the right p_ns
on the zipper foot.
5. Lower the zipper foot on the right side
at the bottom of the zipper so that the
needle pierces the fold and the z_pper
tape,
6. Sew through the fold and the zipper
tape to the point where the slider begins.
7. Lower the needle to hold the fabric and
raise the presser foot.
J
8. Open the zipper.
9. Lower the presser foot and stitch the
rest of the seam.
41