Kenmore 19501 Owner's Manual page 21

Prepare the Bobbin (Continued)
_iens=tSeu= ?g
NOTE: The Pattern Indicator will read "SP" to show the machine Is
winding the bobbin.
7. Press the foot control gently to start the machine,
NOTE: After the bobbin ts slightly filled, stop and cfip the thread coming
from the top of the bobbin.
8. Slowly start the machine again and wind the thread until the bobbin
stops.
Bobbin
winder
stopper
! "-..
9. Push the bobbin winder spindle to the teft and clip the thread,
10, Remove the bobbin,
11. Push _n the clutch to put power back into the needle,
NOTE: If you do not push in the clutch, the machine will not run when
you press the foot control.
2O