Other Conventions; Fcc Information - 3M XT-1 Installation Manual

Overview

Other Conventions

FCC Information

3M Headset Intercom System Model XT-1 Installation Manual
Page 6 of 54
System Warnings
To reduce the risks associated with hazardous voltage:
•
Disconnect power to the receptacle before installing or removing the
Base Station Power Supply. When removing receptacle cover screw,
cover may fall across plug pins or receptacle may become displaced.
Use only with duplex receptacle having center screw. Secure unit in
place by receptacle cover screw.
•
If power supply is supplied with a grounding pin, connect directly to a
grounding receptacle – 3 prong.
To reduce the risks associated fire & property damage:
• Do not open, crush, expose to heat above 200 °F or incinerate the
battery.
•
Always replace batteries, battery chargers and power supplies with
3M approved units acceptable for use in this system to avoid system
function & safety concerns.
To reduce the risks associated with environmental contamination due to
battery pack & to lead in the solder:
•
Dispose of batteries, power supplies, battery charger and base
station in accordance with federal, state & local requirements. If
preferred, return these components to 3M Service Center for
disposal.
Important Notes and Notes
Important Note:
It is strongly recommended that you pay attention to information inside of an
"Important Note:" box.
Note:
You may find information inside of a "Note:" box helpful.
Note:
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense.
WARNING
CAUTION
Rev 1.0 © 3M 2007 November