Change The Night Volume; Registering Headsets - 3M XT-1 Installation Manual

Change the Night Volume

Registering Headsets

3M Headset Intercom System Model XT-1 Installation Manual
02 Monitor Volume
2. Select
3. To enable or disable the monitor playing greeter messages, change the
value for
4. To change the volume level, select a new value for
Messages: Volume
You can assign a standard reduction in the volume level of the customer order
point speaker for night hours when lower volume is typically required. With the
night volume set, the system automatically adjusts the volume during night
hours, then back to normal during the day.
To change the night volume setting:
1. Enter the configuration mode, see page 29.
2. Select a new value for
Volume At Night By
level.
Notes:
Night Volume is never higher than Day Volume.
Night volume reduction is a subtracted value, not the resulting level;
therefore, if it is the same as the day volume level, the speaker will turn off at
night.
You cannot change the day outbound talk volume on this screen, only the
reduction amount identified above.
Each headset must be registered to a base station before it can be used. Once
registered, it should not need to be registered again unless it is intentionally
removed.
Add Headsets
Each headset has a unique identification number. The number is imprinted on
the headset and broadcast to the base station whenever it is turned on.
Notes:
One headset should not be registered to more than one base station at any
given site, whether or not the bases are interconnected. Remove the headset
from the existing base station before adding it to a different one.
To register a headset:
1. Enter the base station configuration mode, see page 29.
04 Registration
2. Select
3. Power on the headset when prompted.
4. Wait up to two minutes for
Registered!}
5. Repeat step 3 for additional headsets.
6. Press
Mode
.
Greeter Messages: Enable
. The range is 0 (silent) to 20 (maximum).
03 Night Volume
. The range is 0 to the current day volume
1 Add New Headsets
>
{Headset xxxxxxx Has Been
to appear at the bottom of the display.
when finished.
Configuration
ON OFF
to or .
Greeter
Reduce DriveThru
>
.
Rev 1.0 © 3M 2007 November
Page 35 of 54