CYBEX VR1 Owner's And Service Manual page 21

F. Remove guide rod cap and spring and set aside.
G. Repeat steps 7D - 7F for other guide rod.
H. Using a 3/16" pin punch and hammer, carefully remove roll pin securing cable end to top weight
connector. See Figure 3.
I. Carefully lean guide rods slightly outward.
damage lower guide rod caps.
Cable End
Roll Pin
Figure 3
J. Slide top weight up and out of machine and carefully set aside.
K. Have an assistant hold guide rods vertical.
L. Carefully remove each weight plate and set aside.
M. Wipe guide rods clean over entire length. Lubricate with light coating of medium weight
automotive engine oil.
8. Installing weight plates.
A. Have an assistant hold guide rods vertical.
B. Carefully align weight plates (removed in step 7M) over guide rods and slowly lower each weight
plate. NOTE: Install weight plates in reverse order as removed in step 7M. NOTE: When
installing weight plates, position plates so wide edges of bushings face upward and narrow
edges of bushings face downward. See Figures 4A and 4B.
Figure 4A
Cybex VR1 Owner's Manual
Top Weight
Connector
WIDE bushing
edge faces
upward
NOTE: Excessive pressure on guide rods may
NOTE: The narrow
bushing edge must face
downward.
Figure 4B
NARROW
bushing edge
Assembly
Page 4-3