Jp2: Wake On Lan Connector; Jp5: Cpu Voltage Testing Connector; Reset Switch: Pins 9 And 19; Hard Disk Drive Led Connector: Pins 10 And 20 - TMC TI6NL User Manual

Reset Switch: Pins 9 and 19

The reset switch allows the user to reset the system without
turning the main power switch Off and then On. Orientation
is not required when making a connection to this header.

Hard Disk Drive LED Connector: Pins 10 and 20

This connector connects to the hard drive activity LED on
control panel. This LED will flash when the HDD is being
accessed.

5.13 JP2: Wake on LAN Connector

JP2 is a 3-pin header for the Wake on LAN function on the motherboard.
The following table shows the pin out assignments of this connector.
Wake on LAN will function properly only with an ATX power supply
with 5VSB that has 200mA.
1 2 3

5.14 JP5: CPU Voltage Testing Connector

JP5 is a 10-pin connector used for testing CPU voltages. This connector
should not be short/closed.
TI6NL User's Manual
Chapter 5 Installation
J20 Pin # Signal Name
10
20
JP2 Pin # Signal Name
1 +5VSB
2 Ground
3 Wake on LAN
Ground
5V
25