Performance Data Sheet; Filter - Kenmore 795.5103 Series Use & Care Manual

Filter Performance Data Sheet
Model Number ADQ72910902
Use with replacement cartridge ADQ72910902
This system has been tested according to NSF/ANSI 42 for the reduction of the substances listed below.
The concentration of the indicated substances in water entering the system was reduced to a
concentration less than equal to the permissible limit for water leaving the system, as specified in
NSF/ANSl 42.
i ystem tested and certified by NSF International against NSF/ANSl Standard 42 for the
reduction of Chlorine, Taste and Odor and Nominal Particulate Class III.
Substance Average Influent Challenge Avg. Product Average Max.
Influent Concentration Water % Effluent Min. Required
Reduction
Concentration Reduction mg/L
Particulate Class Ill 48,000 7.5 99.9 % 26 > 85%
Particles 5ore to 15om At beast10,000 particles/mL
Chlorine taste and odor 2.0 mg/L 2.0 mg/L _+ 10% mg/L 97.4 % 0.06 mg/L _> 50%
* To a capacity of 500 gallons (1.892 L).
* Note that while the testing was performed under standard labaratory conditions, actual performance may vary.
Application Guidelines / Water Supply Parameters
Service flow 0.5 gpm (1.9 Ipm)
Water temperature 34°F - 100°F (1°C - 38°C)
Water pressure 20 - 125 psi (138 - 862 kPa)
To reduce the risk associated with ingestion
of contaminants due to use with water that is
microbiologically unsafe or of unknown
quality.
Do not use with water that is
microbiologically unsafe or of unknown
quality without adequate disinfection before
or after the system.
Systems must be installed and operated in
accordance with manufacturer's recommended
procedures and guidelines.
E_CAUTION
To reduce the risk of property damage due to water leakage:
• Read and follow Use instructions before installation and use of
this system.
• Install on COLD water lines only.
• Company with all state and local plumbing codes.
Never install or operate where inlet water pressure may exceed
125 psi (862 kPa).
• Protect filter from freezing. Remove filter in temperatures
below 34 ° F (1° C).
• Replace cartridge at specified service interval. Cartridge
MUST be replaced at least every 6 months.
• After replacing the water filter cartridge, dispense 2.5 gallons
(9.46 liters) of water to purge the system, depressing and
releasing the dispenser pad in cycles of 30 seconds ON and
60 seconds OFF. Discard the purged water.
To purchase a replacement filter, visit your local Sears store or
call 1-800-4-MYHOME ®.Visit us on the web at www.sears.com
Product distributed in the United States
by Sears Brands Management Corporation,
Hoffman Estates, IL 60179
24