Filter; Water Filter - Kenmore 795.5103 Series Use & Care Manual

WATER FILTER
• Filter Reset: When the Filter Reset icon turns on, you
have to change the water filter. Press the Filter Reset
button c,,_T_, for 3 seconds to turn the icon off.
HOL_3S_C
Before removing or installing water filter:
1. IMPORTANT: Turn off household water supply.
2. Take out the top shelf and move it to the lowest level,
(\2/)
Installing the water filter
1. Remove the red cap from the filter.
2. Hold the filter with the unlock symbol _ facing
towards you as shown in the figure below. Insert the
filter into the filter receptacle on the right side of the
refrigerator compartment.
/
/
Removing the water filter:
1. For first-time installation, remove filter substitute cap
(_) by turning it counterclockwise and pulling it down.
The substitute cap must be retained for the future.
If the filter is removed and not replaced, it is
necessary to reinstall the substitute cap to prevent
water leaks from the filter housing.
,\
,/
/ • •/
3. Push the water filter up into the filter receptacle and
rotate it clockwise to lock it into place. Once installed
correctly, the lock symbol i_ should be facing you and
you should not be able to rotate the filter clockwise any
more,
S
!
NOTE: After installation, if you notice that the lock symbol
is not facing you or you can continue to rotate
the filter clockwise; remove the filter and repeat
installation to prevent water leaks.
After installing water filter:
2. For filter replacement, remove old filter by turning it
counterclockwise and pulling it down.
1. Replace the shelf to the initial position.
2. After installing filter, turn on household water supply.
3. Dispense 2.5 gallons (9.46 liters) of water to purge the
system, depressing and releasing the dispenser pad in
cycles of 30 seconds ON and 60 seconds OFF. Open
the refrigerator door and check the shelf area for water
leaks.
To purchase replacement water filters, call
1-800-4-MY-HOME ®.
23