Adjusting Control Settings; Icemaker Operation - Kenmore 795.5103 Series Use & Care Manual

ADJUSTING CONTROL SETTINGS
Give the refrigerator time to cool down completely
before making final adjustments. It is best to wait 24
hours before doing this. The initial settings mentioned in
CONTROL PANEL FEATURES section should be
correct for normal household refrigerator use.
The refrigerator control functions as the thermostat for
the entire appliance (refrigerator and freezer sections).
The colder the setting, the longer the compressor will
run to keep the temperature colder. The freezer control
adjusts the cold air flow from the freezer to the
refrigerator. Setting the freezer control to a lower
temperature keeps more cold air in the freezer
compartment to make it colder.
If you need to adjust temperatures in the refrigerator or
freezer, start by adjusting the refrigerator and allow 24
hours for the temperature to stabilize. If it is too warm or
too cold, then adjust the freezer control.
Use the settings listed in the chart below as a guide.
Always remember to wait at least 24 hours between
adjustments.
CONDITION/REASON:
m REFRIGERATOR section too
warm
- Door opened often.
- Large amount of food added.
- Room temperature very warm.
m FREEZER section too
warm/ice not made fast enough
- Door opened often.
- Large amount of food added.
-Very cold [below 55°F (13°C)]
room temperature.
(Compressor does not cycle
often enough).
- Heavy ice usage.
-Air vents blocked by items.
m REFRIGERATOR section too
cold
-Controls not set correctly for
your conditions.
m FREEZER section too cold
-Controls not set correctly for
your conditions.
RECOMMENDED
ADJUSTMENT :
Set the Refrigerator
control one degree
colder; wait 24 hours
for the new setting to
take full effect before
making another
adjustment.
Set the Freezer control
one degree colder;
wait 24 hours for the
new setting to take full
effect before making
another adjustment.
Move items out of
airstream
Set the Refrigerator
control one degree
warmer; wait 24 hours
for the new setting to
take full effect before
making another
adjustment.
Set the Freezer control
one degree warmer;
wait 24 hours for the
new setting to take full
effect before making
another adjustment.
ICEIVlAKER OPERATION
Personal Injury Hazard
Avoid contact with the moving parts of the ejector
mechanism, or with the heating element that releases
the cubes. DO NOT place fingers or hands on the
automatic icemaking mechanism while the refrigerator
is plugged in.
A newly-installed refrigerator may take
12 to 24 hours to begin making ice.
Indicator Light
\
Shutoff Arm
Ice Cube size
selector button
Power Switch
The icemaker will produce 6 cuber per cycle,
approximately 100 cubes in a 24 hour period, depending
on freezer compartment temperature, room temperature,
number of door openings and other operating conditions.
If the refrigerator is used before the water connections is
made to the icemaker, set the power switch to OFF (O).
Throw away the first few batches of ice to allow the water
line to clear.
Be sure nothing interferes with the sweep of the shutoff
arm, the icemaker will stop producing ice.
When the bin fills to the level of the shutoff arm, the
icemaker will stop producing ice.
It is normal for several cubes to be stuck together.
If ice is not used frequently, old ice cubes will become
cloudy, taste stale, and shrink.
18