Kenmore 795.5103 Series Use & Care Manual page 31

NOT DISPENSING iCE
Check if... Then...
All the doors are not closed completely. Ice will not dispense if any of the refrigerator doors are left
open, Check if something is holding the door open,
The dispenser display is locked. Press and hold the Door Alarm button for 3 seconds to
unlock the control panel and dispenser,
Ice is not selected on the dispenser. The dispenser can be set for ice or water. Make certain
that the control panel is set for the proper operation.
Press the dispenser Ice & Water button on the control
panel to cycle through the ice and water options.
The ice dispenser is not used often. Check the ice bin for ice cubes clumping/sticking together.
If they are, break up the ice cubes to allow for proper
operation.
Ice bin is not installed correctly. Be sure to install the ice bin firmly into position.
New installation. Wait 24 hours after icemaker installation for ice
production to begin. Wait 72 hours for full ice production.
See the CONTROL PANEL FEATURES section,
Ice cubes are stuck in the delivery chute. Use a plastic utensil to clear the delivery chute.
The ice dispenser is stalling while dispensing Change the ice button from crushed to cubed.
crushed ice. If cubed ice dispenses correctly, depress the button for
crushed ice and begin dispensing again.
Icemaker power switch in the OFF (0) position. Move the switch to the ON (I) position.
Water supply turned off or not connected. See the CONNECTING THE WATER LINE section.
NOT DISPENSING WATER
Check if... Then...
The dispener display is locked, Press and hold the Door Alarm button for 3 seconds to
unlock the control panel and dispenser,
New installation, Flush and fill the water system,
Refrigerator or freezer doors are not closed Water will not dispense if any of the refrigerator doors are
properly, left open,
Water supply turned off or not connected, See the CONNECTING THE WATER LINE section,
The water pressure is less than 40 psi. The water pressure to the home affects the flow from the
dispenser,
Home filter or reverse osmosis system is used, This can decrease water pressure. It is recommended
not to connect the supply line to a reverse osmosis
system for optimal operation,
The dispenser is not set for water dispensing, The dispenser can be set for ice or water. Make certain
that the control panel is set for the proper operation.
Press the dispenser button on the control panel to cycle
through the ice and water options,
Water filter needs to be changed, The filter should be changed every 6 months or
more often depending on usage. The filter can
become blocked over time with foreign
particles and reduce the water pressure,
31