Assembling The C25 - Siemens C25 Service Manual

4.4

Assembling the C25

Attention: ESD regulations have to be followed!
1. First you plug in the connector cable of the display in
the retaining clip of the
module (1) and then close the retaining clip (2).
2. Now fasten the display to the radio and control module.
Attention!
In order to position the display exactly, the synthetic
projection on the lower side of the display frame must
be fitted into the hole in the screen lid. The catches
must fully engage.
3. Place the keypad mat, the loudspeaker and its
retaining clip in the upper housing section.
Note:
Please first remove the protective foil from the
loudspeaker.
4. Then check whether the HF-screens
properly secured. Subsequently you place the
and control module in the upper housing section.
Note: On the MMI's display side there is a further RF-
screen.
5. Place the clip on the lower HF-screen lid.
Attention!
The metal projection on the clip must engage with the
recess in the screen lid.
Service Manual C25 / C2588
Sm_C25_lvl2_v10_w97
plug-in connector on the
have been
V 1.0
Page 12 of 32
Private Communication Systems
Mobile Phones
1
radio
2
ICP CD ST
R. Fleuren
02/99