Xerox DocuPrint P8e Service Manual page 100

1.03).
8 Wait approximately 1-2 minutes until the message "The printing is completed!" is displayed and
the LED's are blinking simultaneously. Switch off the printer.
9 Switch the printer back on. The printer should go to an on-line condition with the ready LED on.
10 At the C> prompt, type: fprt xerox-lt.XXX lpt1 (XXX represents the version level, i.e. 103 for
version 1.03). This tests 115 VAC systems with a default for letter size paper
OR
At the C> prompt, type: fprt xerox-a4.XXX lpt1 (XXX represents the A4letter size paper.
The ready LED should stay on.
11 Switch off the printer and then switch it back on.
12 Print a configuration sheet by holding the On/Off-line button down for about 5 seconds until all
the LEDs are blinking, then release the button.
13 The configuration sheet should list a OS version that corresponds with the version you have just
installed.
General Procedures and Information
7/98
5-28 Xerox DocuPrint P8e Service Manual