Table of Contents
Advertisement
Setting Warmer Drawer Controls
•
Preparing Bread Dough for theWarmer Drawer
•
Removing & Replacing Warmer Drawer
Preparing
Bread Dough for the Warmer
Drawer
The Warmer Drawer has a "Proof Bread" feature that can be used to help
prepare bread dough. The recommended length of time to keep the bread
dough in the Warmer Drawer is about 45-60 minutes. Be sure however to
follow the recipe's recommended times.
The prepared bread dough should be placed in a large bowl because the
dough will nearly double in volume, Arrange the Warmer Drawer Rack in
the downward position (See Fig. 1). Place the bowl on the rack in the
Warmer Drawer and follow the Warmer Drawer and Bread Proof Control
setting instructions at the top of this page.
To Remove and Replace Warmer
(Warm & Ready
TM)
Drawer
Fig.1
Rack in downward
position
Left=hand rail and release
Right=hand
rail and release
Fig. 3
Fig. 2
Glide
Fig. 4
Removing
and replacing
the warmer
(Warm & Ready
TM)
drawer
iii ............
Electrical Shock Hazard can occur and
result in serious injury or death. Disconnect appliance from
electric power before cleaning and servicing the warmer
drawer.
To remove the warmer drawer:
1.
Turn powerOFF before removingthewarmerdrawer.
2.
Open the warmer drawer completely.
3.
On left warmer drawer rail, locate black release lever and press up with
finger while pulling out slightly on the drawer handle. On right warmer drawer
rail, locate black release lever and press down with finger while pulling out
slightly on the drawer handle (See Fig. 2).
4.
The warmer drawer should now be released from the rails. Remove warmer
drawer (using level & square motion) completely away from the appliance.
To replace
the warmer drawer:
1.
Pull the bearing glides to the front of the outer compartment glide channels
until they snap into place (refer to Fig. 4).
2.
Carefully line up both sides of the warmer drawer glide rails to the outer
compartment glide channels located inside the empty warmer drawer
compartment (Refer to Fig. 3).
3.
While holding the warmer drawer level and square using the warmer drawer
handle, push (DO NOT FORCE) the warmer drawer all the way into the
outer compartment glide channels all the way into the range. Pull the
drawer open again to verify the glides have seated.
4.
If you do not hear the levers "click" or the bearing glides do not feel seated
remove the warmer drawer and repeat steps "1" through "3". This will
minimize possible damage to the bearing glides.
NOTEI
The warmer draWer will NOT operate while in the Self:Clean and
"Oven Lockout', modes
13
Advertisement
Table of Contents
