Kenmore 79078023300 Installation Instructions Manual

iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iNSTALLER.
iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE.
READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or
use
gasoline or other flammable vapors and liquids
in the vicinity of thls or any other appliance.
_f the
informationin this manual is not
followed exactly, a _re
or explosion may result causing property damage, persona_ injury or death.
FOR YOUR SAFETY:
m Do not store or use gasoline or other flammable vapors and liquids
in the vicinity of thls or any other appliance.
WHAT TO DO iF YOU SMELL GAS:
* Do not try to light any appliance.
* Do not touch any electrlcal switch; do not use any
phone in your
building.
" Immedlafely call your gas supplier from a neighbor's phone. Fellow
the gas suppller's instructions.
* If you cannot reach your gas supplier, call the fire department.
Installatlon and servlce must be performed by a quafffled installer,
service agency or the gas supplier.
* All appliances can tip.
* Injury to persons
could resuff.
* Install anti=tlp
bracket packed with
your appliance.
e See
installation
Instructlons.
Note: For appliance installed in the
State of Massachusetts see page 2.
Front
view
49"
Maximum
A_
36-+ I/8"
/
,\
Front Typical cablnef installation Side ....
I
view "^"_
30" Minimum
Minimum to 7'2 _ //_ t Minimum te forMaXlmUmcabinets_13"_depth
wall on either 18 _ cabinets on /_
side of range _ either side above range t°P'L_ I[/I
above 36" height. _, ef range
30 1/8"_
0" ¢=....... bel ..... king top and at .....f range
30" minimum clearance between the top of the cooking
surface and the bottom of an unprotected wood or
metal cabinet; or 24" minimum when bottom of wood
or metal cabinet is protected by not less than V_" flame
retardant millboard covered with not less than no. 28
MSG sheet steel, 0.015" stainless steel, 0.024" aluminum
or 0.020" copper. The minimum clearance is 0" for the
rear of the range. Follow all dimension requirements
provided above to prevent property damage, potential
fire hazard, and incorrect countertop and cabinet cuts.
Clearances and Dimensions
1. Locatlon=Check location where the range will be
installed. Check for proper electrical and gas supply_and
the stability of floor.
Printed in Canada
Avoid locating cabinet storage space above the surface
burners to eliminate the posslblllfy of cabinets catching
on fire, or personal burns from reaching for the cabinets
over the heated units. Avoid locating cabinet storage
space above the surface burners. The absence of cabinets
will eliminate the chance of cabinets catching
on fire,
and
eliminate the possibility of receiving personal burns from
reaching for the cabinets over flaming surface burners.
if cabinet storage is to be provided, risk can be reduced
by installing a range hood that projects horizontally a
minimum of 5" beyond the bottom of the cabinets.
2. Dimensions that are shown must be used. Given
dimensions provide minimum clearance. Contact
surface must be solid and level.
318201794 (1012) Rev. A