Installation and Tapping
ArctiCold Draft Dispenser
Tapping a Single Valve Keg
Be sure beer faucet is in closed position.
■
Align keg lugs with lug openings on bottom
■
of coupler.
1
Turn clockwise
⁄
turn. Pull handle out and
■
4
down. Keg is now tapped.
Open shut-off valve on CO
■
inside of the cabinet.
IMPORTANT: Be sure to close this valve
when untapping keg.
CAUTION: do not use keg coupler as a
handle to lift keg.
Priming the Beer System
Plug in top refrigeration deck, (15-amp plug),
■
and allow condensing unit to cycle at least
once, (circulation pump will run continuously),
before tapping the keg.
Couple beer keg to system. Beer temperature
■
in keg should not exceed 42°F.
Apply 14-17 PSIG carbon dioxide gas.
■
Open faucet and pour for approximately 15
■
seconds.
Close faucet and wait for at least 15 minutes to
■
allow beer system to "pack".
You are now ready to tap beer.
■
Form No. Z2323
Rev. 06.26.10
(Sankey)
distributor located
2
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice.
Single Valve Keg Coupler
Step 2
4
Step 1
Step 3
OUT
OUT
DOWN
DOWN
1/4
1/4
TURN
TURN