Perlick DP32S Installation And Operation Instructions Manual

Single keg beer dispenser

Advertisement

INSTALLATION AND OPERATION INSTRUCTIONS
SINGLE KEG BEER DISPENSER
IMPORTANT INFORMATION
A Warranty card is enclosed that must be filled out
and mailed to the Perlick Corporation in order to reg-
ister the warranty. If the card is not returned to
Perlick, the warranty period will begin from the date
the equipment is shipped from the factory.
This manual has been prepared to assist you in the
installation of your Single Keg Dispenser and to
acquaint you with its operation and maintenance.
We dedicate considerable time to ensure that our
products provide the highest level of customer
satisfaction. If service is required, your dealer can
provide you with a list of qualified service agents. For
your own protection, never return merchandise for
credit without our approval.
We thank you for selecting a Perlick product and
assure you of our continuing interest in your
satisfaction.
WARNING: When lifting, the full weight of the
cabinet must be supported. Lift from the cabinet
base and not from the top. Improper lifting can
result in severe damage to the cabinet.
8300 West Good Hope Road • Milwaukee, WI 53223 • Phone 414-353-7060 • Fax 414-353-7069
Toll Free 800-558-5592 • E-Mail: Perlick@Perlick.com • www.Perlick.com
MODEL NOS.
DP32S
DS32S

Table of Contents

Specifications.........................................................2
List of Included Parts.............................................3
Tools Required.......................................................3
Plumbing................................................................3
Electrical ................................................................3
Uncrating ...............................................................3
Installing Casters ...................................................3
Placing the Cabinet ...............................................3
Leveling the Cabinet..............................................3
TAPPING
Connecting the Keg Coupler .................................4
Tapping the Keg.....................................................4
Connecting the Regulator......................................4
Adjusting Gas Flow................................................4
Leak Test .......................................................5
2
Gas Cylinder..............................5
2
Gas .................................................5
2
Beer Temperature ..................................................6
Adjusting the Temperature.....................................6
CLEANING
Cleaning the Beer System.....................................7
Cleaning the Cabinet .............................................7
Cleaning the Condenser........................................7
Condenser .............................................................7
Troubleshooting .....................................................9
REPLACEMENT PARTS ................................10-11
Wiring Diagram....................................................12
Form No. Z2268

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DP32S and is the answer not in the manual?

Questions and answers

Summary of Contents for Perlick DP32S

  • Page 1: Table Of Contents

    IMPORTANT INFORMATION A Warranty card is enclosed that must be filled out and mailed to the Perlick Corporation in order to reg- ister the warranty. If the card is not returned to Perlick, the warranty period will begin from the date the equipment is shipped from the factory.
  • Page 2: Specifications

    19 7/8” [505] OPENING 32” [813] FRONT VIEW Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice. Form No. Z2268 DP32S Portable 1 Keg 222 (101) Door Pan & Ceiling: High strength polystyrene. Door Sill: High strength polyethylene.
  • Page 3: Preparing The Cabinet For Use

    Perlick is not responsible for damage in transit. Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice. Single Keg Beer Dispensers Installing Casters Attach four casters to the cabinet bottom;...
  • Page 4: Connecting The Keg Coupler

    Important: Be sure to close this valve when untapping keg. Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice. Form No. Z2268 Single Keg Beer Dispensers Connecting the Regulator to the Cylinder Remove blue plug from regulator fitting.
  • Page 5: Co 2 Leak Test

    DOT specifications. Be sure CO cylinder outlet fitting is free of dust Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice. Single Keg Beer Dispensers or dirt before attaching regulator.
  • Page 6: Temperature

    36-41 degrees F. The control is factory set at 38 degrees F. Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice. Form No. Z2268 Single Keg Beer Dispensers At temperatures lower than 30°...
  • Page 7: Cleaning The Beer System

    The beer faucet may exhibit a white colored substance (yeast build up) if not cleaned on a regular basis. Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice. Single Keg Beer Dispensers Beer Stone: All beer contains calcium which is present from the grains used in the brewing process.
  • Page 8: General Information How To Pour A Perfect Glass Of Beer

    Pouring a Perfect Glass of Beer – Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice. Form No. Z2268 Single Keg Beer Dispensers STEP 1 Start with a clean glass. Place the glass at a 45°...
  • Page 9: Troubleshooting

    (sticking) check valve. Sluggish CO regulator. Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice. Single Keg Beer Dispensers Cloudy Beer: Beer in glass appears hazy, not clear. AUSES Dirty glass.
  • Page 10: Replacement Parts

    Power cord Top evaporator Liquid and Suction line assembly 2 3 4 Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice. Form No. Z2268 Single Keg Beer Dispensers DP32S & DS32S Part #’s...
  • Page 11: Replacement Parts

    57F2P ...CO tank washer 1392R ...Red air hose 529 ...Beer hose 2928D ...Twin gauge CO regulator Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice. Single Keg Beer Dispensers Form No. Z2268...
  • Page 12: Wiring Diagram

    8300 West Good Hope Road • Milwaukee, WI 53223 • Phone 414-353-7060 • Fax 414-353-7069 Toll Free 800-558-5592 • E-Mail: Perlick@Perlick.com • www.Perlick.com Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice. Form No. Z2268...

This manual is also suitable for:

Ds32s

Table of Contents