Perlick DP1KP Installation And Tapping

Single Valve Keg Coupler
Dual Probe Keg Coupler
Installation and Operating Instructions
INSTALLATION and TAPPING
Connecting the Keg Coupler
1. Place one brown leather washer into black beer line connector hose on hex nut
side. Screw connector to stainless steel beverage line on faucet standard. Tighten with
a wrench, but do not over tighten.
2. Make sure lever handle on keg coupler is in the UP (untapped) position. Place one
brown leather washer into wing nut end of black beer line connector hose and thread
onto top of keg coupler. Hand tighten.
3. Place clamp on one end of red air line. Push end over air valve located inside cabinet.
Tighten clamp with screwdriver. Turn shut-off valve to OFF (horizontal) position.
4. Place clamp on the other end of red air line and push over tailpiece on coupler.
Tighten clamp with screwdriver.
CAUTION: DO NOT USE KEG COUPLER AS A HANDLE TO LIFT KEG.
Tapping a Single Valve Keg (Sankey)
1. Be sure beer faucet is in closed position.
2. Align keg lugs with lug openings on bottom of coupler.
3. Turn clockwise, 1 /
4
4 . Open shut-off valve on air divider located inside cabinet.
Important Note: Be sure to close this valve when untapping keg.
Tapping a Dual Probe Keg (Hoff-Stevens)
Plastic
protector
cover
Step 1
1. Be sure beer faucet is in closed position. Remove plastic protector cover from keg.
2. Be sure that Figure 8 washer is intact. (See Step 2.) Replace if missing, split, or worn.
3. Check that air inlet valve is tight...air line must contain Thomas valve (check valve)
to prevent beer from backing up into air lines.
4. Before inserting probes into keg (large probe to large hole; small probe to small hole),
inspect valve holes for foreign material. Tighten coupler nut by hand until seated.
5. Open shut-off valve on air divider located inside cabinet.
Important Note: Be sure to close this valve when untapping keg.
(when supplied by Perlick)
turn. Pull handle out and down. Keg is now tapped.
Figure 8
Step 2 Step 3
PARTYMASTER DISPENSER
Black Beer
Connector
Wing Nut
Thomas
Valve
Brown
leather
washer
Step 4
Form No. Z2022A
2/25/98
Step 5
1