Using The Remote Control - Philips DVDR9000H User Manual

Remote Control

Using the remote control

A
Open the battery compartment.
B
Insert two batteries type R06 or AA,
following the indications (+-) inside
the compartment.
C
Close the cover.
CAUTION!
– Remove batteries if they are
exhausted or if the remote control
is not to be used for a long time.
– Do not mix batteries (old and new
or carbon and alkaline, etc.).
– Batteries contain chemical
substances, so they should be
disposed of properly.
14
dvdr9000h_eu_eng2.indd 14 dvdr9000h_eu_eng2.indd 14
(continued)
Using the remote control to
operate the system
A
Aim the remote control
directly at the remote
sensor (iR) on the front
panel.
B
Select the desired function
(for example
C
To control other devices
using this remote control,
press SELECT DEVICE
to select the mode
you wish to control (for
example SACD, TV).
The selected source mode
will light up on the LED panel for a few
seconds to confi rm your selection.
Using the alphanumeric keypad to
enter the characters
– Press a number button repeatedly until
the required character or the number
appears.
– To enter language-dependent
characters, press
corresponding character, e.g.,: 'å' press
button {2} for 'a' and then press
'å' appears.
– To enter special symbols, press button
{1} repeatedly.
– To select upper/lower case (capital/
small) letters, press a/A.
– To enter a space, press button {1}.
, ).
or on the
until
2005-10-13 9:18:05 AM 2005-10-13 9:18:05 AM