Troubleshooting - Philips DVDR9000H User Manual

WARNING!
Under no circumstances should you try to repair the system yourself, as this
will invalidate the warranty. Do not open the system as there is a risk of
electric shock.
If a fault occurs, fi rst check the points listed below before taking the system for
repair. If you are unable to remedy a problem by following these hints, consult
your dealer or Philips for help.
Problem (General)
No power.
The message "IS TV ON?"
appears on the display panel.
The buttons on the recorder
do not work.
Remote control does not
work.
No picture.
91
dvdr9000h_eu_eng2.indd 91 dvdr9000h_eu_eng2.indd 91
Solution
– Press the STANDBY-ON button on the front of the recorder to
turn on the system.
– Make sure the AC outlet has power.
– This recorder will not operate until you complete the fi rst
installation. Read chapter "Step 3: Installation and Set-up" for
details.
– There is a technical problem. Disconnect the recorder from the
power outlet for 30 seconds, then connect again. If the recorder
still will not operate, then reset it to the default factory settings :
1) Disconnect the recorder from the power outlet.
2) Press and hold down STANDBY-ON button on the front of
the recorder while reconnecting to the power outlet.
3) Release STANDBY-ON button when "IS TV ON?" appears
on the display. All the information stored in the memory
(programmes, time) will be cleared. You may need to reset
the recorder settings after completing the basic installation.
– Aim the remote control directly at the sensor on the front of
this recorder (not towards TV). If the recorder receives a signal
from the remote control, the icon D will appear on the display.
– Remove any obstacles between this recorder and the remote
control.
– Batteries are weak, replace the batteries.
– The remote control's manufacturer code returned to the default
setting when you replaced the batteries. Reset the code (page
15).
– Press SELECT DEVICE to select the correct mode.
– Turn on your TV and set to the correct Video In channel for the
recorder. You may go to Channel 1 on your TV, then press the
channel down button on your TV's remote control until you see
the TV programme.
– Check the video connection between this recorder and the TV.
– It may be due to the recorder's video output setting not being
matched to the video connection. You can reset the recorder as
below :
1) Disconnect the recorder's ~MAINS from the power supply.
2) Hold down on the recorder whilst reconnect its ~MAINS
to the power supply.

Troubleshooting

2005-10-13 9:18:24 AM 2005-10-13 9:18:24 AM
91