ProForm Crosswalk 2.0 XT User Manual page 11

9. Attach the console assembly to the Uprights
(53, 54). Start all six M8 x 15mm Bolts (8) with
six M8 Star Washers (5) into the Uprights.
Then, firmly tighten all six Bolts.
10. Attach the Latch Housing (48) and the Latch
Housing Spacer (109) to the Left Upright (53)
with two #10 x 1" Tek Screws (112); start both
Tek Screws before tightening either of them.
Make sure that the large hole in the Latch
Housing is on the indicated side.
Locate the Latch Pin Assembly (24). Remove
the knob from the pin. Make sure that the collar
and the spring are on the pin. (Note: If there are
two collars, place one on each side of the
spring.) Insert the pin into the Latch Housing
(48). Then, tighten the knob onto the pin.
9
8
5
5
53
10
24
48
Knob
112
Large Hole
11 11
Console
Assembly
8
5 8
5
54
53
109
Collar
Pin
Spring