Removing The Shelf Supports; Oven Ceiling - Zanussi ZOD35511W User Manual

Stainless steel or aluminium appliances
Clean the oven door with a wet
sponge only. Dry it with a soft cloth.
Do not use steel wool, acids or
abrasive materials as they can
damage the oven surface. Clean the
oven control panel with the same
precautions.

Removing the shelf supports

To clean the oven, remove the shelf supports.
1
Pull the front of the
1
shelf support away
from the side wall.
Install the shelf supports in the opposite
sequence.

Oven ceiling

WARNING!
Deactivate the appliance before you
remove the heating element. Make
sure that the appliance is cold.
There is a risk of burns.
Remove the shelf supports.
You can fold down the heating element on the
oven ceiling to clean the oven ceiling easily.
1. Hold the heating element with two hands at
the front.
2. Pull it forwards against the spring pressure
and out along the supports on the two
sides.
www.zanussi.com
2
2
1
Pull the rear end of
2
the shelf support
away from the side
wall and remove it.
The heating element folds down.
3. Clean the oven ceiling.
4. Install the heating element in the opposite
sequence.
Install the heating element correctly
above the supports on the inner
walls of the appliance.
5. Install the shelf supports.
Removing and installing the door
You can remove the door and the internal glass
panels to clean it. The number of glass panels is
different for different models.
WARNING!
Be careful when you remove the
door from the appliance. The door is
heavy.
1. Open the door fully.
2. Fully lift up the clamping levers (A) on the
two door hinges.
A
3. Close the door until it is at an angle of
approximately 45°.
A
15