Removing The Shelf Supports; Cleaning The Oven Door; Catalytic Cleaning - Zanussi ZOA35802BK User Manual

Cleaning the door gasket
• Regularly do a check of the door gasket. The
door gasket is around the frame of the oven
cavity. Do not use the appliance if the door
gasket is damaged. Contact an Authorised
Service Centre.
• To clean the door gasket, refer to the
general information about cleaning.

Removing the shelf supports

To clean the oven, remove the shelf supports.
CAUTION!
Be careful when you remove the
shelf supports.
1. Pull the front of the shelf support away from
the side wall.
2. Pull the rear end of the shelf support away
from the side wall and remove it.
1
Install the removed accessories in the opposite
sequence.

Catalytic cleaning

CAUTION!
Do not clean the catalytic surface
with oven sprays, abrasive cleaning
agents, soap or other cleaning
agents. This will damage the
catalytic surface.
Spots or discolouration of the
catalytic surface have no effect on
catalytic properties.
18
2
WARNING!
Keep children away when you clean
the oven at a high temperature. The
oven surface becomes very hot and
there is a risk of burns.
Before you turn on the catalytic
cleaning remove all the accessories
from the oven.
The cavity with a catalytic coating is self-
cleaning. It absorbs fat.
To support the self-cleaning procedure, heat
the empty oven on a regular basis.
1. Clean the oven floor with warm water and
washing up liquid, then dry it.
2. Set the function
3. Set the oven temperature to 250 °C and let
the oven operate for 1 hour.
4. When the oven is cool, clean it with a soft
and wet sponge.

Cleaning the oven door

The oven door has two glass panels. You can
remove the oven door and the internal glass
panel to clean it.
The oven door can close if you try to
remove the internal glass panel
before you remove the oven door.
CAUTION!
Do not use the appliance without the
internal glass panel.
1. Open the door fully and hold the two door
hinges.
2. Lift and turn the levers on the two hinges.
.
www.zanussi.com